To win work, contractors generally have to bid against other suppliers. To make an accurate bid, they estimate the time and materials required to complete the job. They measure the area to be painted and discuss the type of finish the customer requires. They assess the quality of the surfaces to work out how much remedial work they must carry out before painting. They might have to remove old paint or wall coverings, or repair cracks and other damage. They also calculate the cost of any essential equipment, such as scaffolding for exterior walls.
I would not recommend this company for the following reasons:1. Original appointment was very specific to them on what was needed and to take photos for 3 apartment unit plumbing fixture repairs. One unit had a bathroom tub/shower backup.2. No photos taken, 3 trips later and only 1 unit completed to satisfaction. (Backup) 3. Other faucets unable to find on line with their suppliers and repair 4. Had to find another plumbing company to complete the jobs. 5. Invoicing had to be redone as not in detail of job address for tax purposes 6. Bad communication throughout the project process with their internal customer service. Their technician and project manager ordering parts. 7. For the back up. Did not bring out correct snake on both trips and had to replace lines as too small to break through backup. Costing over $800 for 3 trips just to complete that situation out. 8. Ordered the wrong parts when 2nd trip out since no photos taken to confirm what was needed. Very dissatisfied and will never ask them to work in any of our rental properties again.
You will want to use the highest quality exterior home paint your budget will allow for your project -- not only because it will look the nicest, but also because it will save you money in the long term by offering better coverage and durability. Better coverage means fewer coats and fewer work hours for your painter; better durability means that you won't have to spend money to paint the exterior of your home again in just a few years. How do you know how much paint you're paying for? Here's some helpful math:
Work with a professional painting contractor. If you haven’t done so already, sign on to work with a painting company near you. As part of a professional team, you’ll learn the tricks of the trade and work in a variety of different environments, both commercial and residential. There’s no better way to accumulate practical experience than to do it on the job.[8]
This was very helpful. I wonder if i would really follow through and check to see if my painter was cheating me. I used a painter I found on Angie's List. This was 5 years ago. He did a great job. I know he did patching only for about a day and a half. We decided on the kind of paint before he started. that is what he used. I don't know if I could stay on top of him and watch him open every can of paint.
Freshly painted walls often look blotchy. The color is uniform, but the sheen isn’t consistent. This usually occurs over the holes and cracks you patched with a filler or drywall compound. The porous fillers absorb the paint, dulling the surface (a problem called “flashing”). When light hits these dull spots, they stick out like a sore thumb. The smooth patch also stands out in contrast to the slightly bumpy texture of the rest of the wall. A quick coat of primer is all it takes to eliminate flashing and texture differences.
Not only do I agree with what you are saying; but, I will not use Angie's List for referrals again. Their "A" rated painter did some of the exact things they are now warning against; however, they are still rated "A". I sent in a review and it took eight weeks to post it. They allowed the contractor to lie about what happened as a response. I had proof and photos. Angie's List is a scam; instead ask neighbors and friends for referrals!

Even after collecting bids and comparing initial impressions of different home painters in Atlanta, you may be unsure who to hire, or even how to evaluate whether they do good work or not. That's understandable in a city where Bobby Petrino didn't even finish out one football season at the helm of the Atlanta Falcons! When it comes to Atlanta home painters and their work, the key to evaluating quality is focusing on the details. Determining whether past paint jobs have held up over time, for example, is a good indication of whether the Atlanta house painter you're checking up on put in the proper amount of prep necessary for the job. Also, don't be afraid to ask to see a sample of the painter's work in person. Almost any paint job looks good from the street or in a well-shot photograph. The question is whether a house painter in Atlanta's work looks equally impressive once you get up close and personal.
Take and pass your contractor’s certification exam. Like the licensing requirements, the content and format of the exam will vary depending on your location. However, the test will almost always include a comprehensive written section, on top of which you may be asked to describe or demonstrate key skills. Upon passing your exam, you’ll have between 1 and 4 years to complete the process of formally registering your business.[11]
Freshly painted walls often look blotchy. The color is uniform, but the sheen isn’t consistent. This usually occurs over the holes and cracks you patched with a filler or drywall compound. The porous fillers absorb the paint, dulling the surface (a problem called “flashing”). When light hits these dull spots, they stick out like a sore thumb. The smooth patch also stands out in contrast to the slightly bumpy texture of the rest of the wall. A quick coat of primer is all it takes to eliminate flashing and texture differences.
Inspect the surface area for holes, cracks or other problems and apply acrylic caulk to fill them in. Use a putty knife to smooth out the caulk and remove any excess to prevent bumps. For particularly thin or narrow crevices, you may have to use your finger to smooth out the caulk. Caulk contracts and shrinks, so apply a second layer once it's dried.

Lap marks are those ugly stripes caused by uneven layers of paint buildup. They occur when you roll over paint that’s already partly dry. (In warm, dry conditions, latex paint can begin to stiffen in less than a minute!) The key to avoiding lap marks  when doing DIY wall painting is to maintain a “wet edge,” so each stroke of your roller overlaps the previous stroke before the paint can begin to dry.
Estimates are one of the most important tools to help you land the next job. During our most recent webinar series on estimating, Fred Yarur of PEP (Painter’s Estimating Program) outlined 10 foundational principles to support effective estimating procedures. Use estimate tools. These enhance your ability to make informed decisions. Estimating is the process of […]

Thanks, all, for your time & efforts adding to the article & comments, especially Dave urging requesting both General Liability AND Worker Compensation insurance certificates to protect from real & fraudulent liability--from my experience especially in California, where insurance fraud is a popular income thief, even causing car collisions to collect.
to be the devils advocate i have been a building contractor 20 of the last 30 yrs. i do know that if you go to a higher sheen of paint and or darker colors then any imperfections in the walls will show up much more dramatically…therefore the painter or a good drywall finisher is needed to prepare the walls extensively. this could cause more expenses…for it takes a lot of time to prep walls (smooth walls..not textured walls) and this cost has to be absorbed.
Riverside and San Marco are neighborhoods on the southern side of Jacksonville. These are some of the older neighborhoods, with many homes dating back to the early 1900s. Painting services in this area cost slightly more because of the older architecture and the larger sizes of the homes. There are newer homes in the Southside neighborhood, which has seen tremendous growth since the 1990s.

To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges when doing DIY wall painting.
Based in the United Kingdom, Ian Linton has been a professional writer since 1990. His articles on marketing, technology and distance running have appeared in magazines such as “Marketing” and “Runner's World.” Linton has also authored more than 20 published books and is a copywriter for global companies. He holds a Bachelor of Arts in history and economics from Bristol University.
I'm an architect and my firm routinely specifies interior finishes for projects so I thought I'd contribute a professional's perspective on the issue of how many coats of paint are deemed "acceptable". The fact of the matter is the average consumer usually isn't a paint expert and can't be expected to know about all the factors that impact coverage. That knowledge is considered "means and methods" and in a court of law, the responsibility lies with the painter or general contractor, not the consumer. What the consumer should be concerned about is the final result-does it look good and is it what you expected? The simplest way to communicate this to your painter is to stipule in your written agreement that the number of coats will be "as required to cover". That way all the guess work about what kind of primer, how many coats, how color affects the scope of work, etc., is removed from the consumer's responsibility and resides where it belongs-with the professional. In the contract that's why retention is always a good idea-typically 10% is withheld from payment until the job is completed to the satisfaction of the customer. Of course in return you as the customer have to be reasonable about what constitutes a completed job. Just my $.02.
Referred by a neighbor, I got an estimate from Excel along with two other companies to paint the exterior of our home; their estimate was the cheapest by at least a grand compared to the other companies. They contacted me a couple of weeks earlier than expected and offered to do the power washing a week or so earlier due to an opening in their schedule, another opening got them to our house 2 weeks earlier than planned to paint!!!
FIRST: Unless you can stay in business painting 1 bedroom at a time for $500-$1000, which you can't, then you will be taking on several thousand dollar contracts that require thousands in Labor and Materials to fulfill the order. Multiply that by 3-4 jobs at one time or in our case 15-20 jobs at a time, YOU NEED TO TAKE DEPOSITS!!! It is horrible business not to take deposits. There are many jobs where its not possible to get a deposit and that is built into or pricing accordingly. If we are not getting a deposit, there is a finance charge built in, contractors are not banks. If you don't have a good feeling about a deposit, your hiring the WRONG CONTRACTOR. Hire people you know or well established businesses.

It is often necessary to have a rental property painted -- whether it's to make it your own before you move in or to clean it up for someone new when you move out. Some buildings and landlords have pre-selected painters, while others will contract companies to paint on an as-needed basis. If your landlord or building doesn't have a pre-selected painter, see if you may be allowed to paint the walls yourself. If you're moving in and selecting a non-neutral color, understand that your landlord may require you to repaint the walls the original color when you move out -- and ensure that you're ready to make that investment down the road.
A thorough scrubbing is a must before painting any exterior surface. It removes the dirt and broken-down paint residues that keep fresh coats from adhering and gets rid of mildew that grows on paint in all but the most arid climates. Most contractors clean with pressure washers, but in the hands of someone unfamiliar with the equipment, these can gouge wood, shatter glass, and drive water behind siding and trim. Using a hose, a pump sprayer, and a scrub brush is slower but safer, and just as effective.

This job is usually done by a professional house painter. The painter will assess the walls, clean, and make any necessary repairs or removal of old wall coverings. They will also tape off any adjacent surfaces and cover nearby furniture and floors with drop cloths. Typically, they will apply a layer of primer, then one to three coats of paint, depending on the color and coverage. Once the paint is dry, they take a final walkthrough to inspect and make any necessary touch ups.


I've seen this done many years ago by a guy who did all sorts of jobs where I lived. My dad caught him painting his boss's roof and he was watering down the paint. We've had a hard time trying to get a painter for our house. We've had a guy that had been remmended by a neighbor and he hasn't showed up to paint for 2 weeks. I want to call him and my husband says no. I'm 69 years old and I'm about ready to go and paint our 2 porches, I've painted all my life and all the inside of our home. Maybe that's the way it should be with everyone that can paint pretty good.
×