Prep. For new work the painter accepts the finish done by the drywall or plaster and once he accepts the work and starts painting he owns any wall repairs. Existing work is a different thing. I take a high intensity light and circle the kinds of defects with chalk so we are all in agreement before they start. Sometimes this results in a higher price and we have to compromise on how much to do...
Getting multiple bids is even more important in the state of Georgia, since contractors of any sort are not required to obtain licensing in order to operate. That makes hiring a painter in the Peach State a bit of a crapshoot, since anybody with a ladder and a paint brush can claim to be professional-grade painter, whether they've got the experience not. This is also why it's not just important to collect multiple bids, but to ask for references and follow up on them. Talking to former customers about their experiences is the best way to go if you want to be absolutely sure you're going to get a quality paint job and with a great price.
The pros were split on this tip. "Masking tape is problematic," says Mark Dixon, a painter in Missoula, Montana, and author of "House Painting Inside and Out" (Taunton Press, 1997). "Paint can bleed behind the tape, or remove the paint it's stuck to." Another problem is bridging. "Latex paints form a skin," says Dixon. "Removing painted tape can tear the skin, resulting in a ragged rather than a sharp line." Lastly, taping takes time. "Learning how to cut in with a brush takes practice, but if you can do it, you'll leave most tapers in the dust," Dixon says. (Cutting in is painting just the surface you want, not the surface adjacent to it — for example, where a wall meets the ceiling.) On the other hand, "If you can't cut in, you can't beat tape," says Span. The pros we spoke with all recommend painter's (blue) tape because it's easier to remove than masking tape. To prevent bleeding, Span uses a putty knife to bed the tape. After letting the paint dry, he scores the edge of the tape line with a utility knife to avoid tearing the paint.
Steve, not only did you come off with an edge regarding the article written for Angie's list but you came awfully close to being slanderous. The article was written if you will have read his bio by a very well established professional painter. The issue regarding the deposit was put in question by a responder. I have read your response in full as you suggested, and companies as large as yours are just as likely to use the tricks of the trade as the small guy as you suggest, if not more so. A large company has less oversight and workers get lazy with the boss not looking over their shoulder. I have had experience in this area, and thought that i was dealing with a very reputable company that had been recommended by a couple friends, my insurance company, and my adjuster who had dealt with the company. I had terrible problems with the company, who do full restorations and like your company paint in all areas. To finalize your statement that Established businesses do not cheat customers is completly false and is a very misleading statement. I am suprised that Angies list allowed you to post such an outragious comment. All you have to do is look in the Civil lawsuits section of the Established businesses that are being sued or are under investigation for fraud and cheating their customers!
To begin, move everything out of the room. Every painter we spoke with had a horror story about the time he didn't follow Rule No. 1. Bigger pieces of furniture can sometimes be left covered in the center of larger rooms, but if you are repairing drywall, says Chris Span, of Span's Quality Painting in Mobile, Alabama, "Take everything out. Drywall dust goes everywhere." Remove doors, light fixtures and hardware, and label everything with masking tape. Also, invest in drop cloths. "It's surprising how well a few drops of paint can cover a floor," says Rich Maceyunas, of Maceyunas Painting and Wallpaper in Waterbury, Connecticut. Buy high-quality drop cloths, such as canvas or paper-backed plastic. (Paint soaks right through lightweight fabrics and bedsheets.) Plastic sheeting works, but it's very slippery and doesn't absorb drips.
To get basic measurements, measure the length and width of each wall you want to paint in inches. Multiply the length and height together, and divide by 144. This will give you the square footage for each wall. A gallon of paint typically covers around 400 square feet. In some cases, you may need a primer 2 first, then a single coat of paint, meaning that you may need one gallon of primer and one gallon of paint to cover 400 square feet. However, if the wall requires multiple coats, this will increase the total amount of square footage required, and therefore the amount of paint.
Sean and TJ painted the entire interior of our townhouse and were a pleasure to work with. Excellent job of prepping and cleaning up at the end of each day. We changed our minds on the color selection of our downstairs walls TWICE, but they didn't make us feel like idiots (even though we felt that way) and were patient with the process. Bryan, the owner, is detail oriented and very easy to work with. We would definitely recommend them!!!
Keep an eye on the new cans as they're being brought in. Make sure they look new and don't have paint in the rim of the can. If it's a five-gallon bucket, check to see whether the lid is still sealed on with the plastic strip. The only time it's acceptable to mix water in the paint is when you're using a deep or ultra deep base paint to reduce its stickiness, which is rare with new paint technology. Dark primary colors are composed almost entirely of tint that makes it very hard to work with without adding water.
Before we start, you will have to choose your color. If you would like to replicate a color already on your wall, you can use an old can of paint for reference, or you can take a chip to the paint store. We can help you identify the color, the finish, and type of paint with our visualizer tools, and we also offer a Color Consulting Service if you need help coming to a decision.
Our team of industrial, commercial & residential paint contractors have many years of experience working on projects of all sizes. All projects are managed and staffed by in-house professional employees from start to finish. With our attention to detail and commitment to excellent customer service, you can be assured that your project will be successfully completed on time and within your budget.
A qualified exterior house painter can walk you through the process of getting your house ready for a new coat of paint, from scraping and sanding to patching and priming. A pro can also recommend the best exterior paint for the job, whether your siding is wood, fiber cement, stucco, vinyl, or even metal. When it comes to getting the work done, your painter will arrive with all the tools and equipment needed to get the job done quickly, correctly and safely.
Some contractors work on time and material others on a firm contract. I would never hire the former and am leary of the latter. A contractor may low-ball a bid to get the job planning to make a killing on change orders. If you say good morning to them, they charge you extra for that. If the contract is not very, very specific and extensively fleshed out or if they display their change order schedule prominently on top, show them the door.