When we checked out their work the next day we found multiple, I mean MULTIPLE, paint splatters all over the place.  On the hardwood floors (had to be at least 10 paint splatters on the ground), paint on the fireplace, clumps of paint on the wall.  There were several areas that needed a paint touch up that weren't.  It seemed like the whole job was done by a kid. We called them and asked if they could come back and basically finish their job.  We told them we will mark all the paint splatters and areas missed with blue paint tape, so when they came back they would know exactly where to look.  We marked probably about 20 areas that needed attention.  Sounds flawless right?
However, David, who works in Excel's office, really left a bad taste in our mouth for the whole project. We didn't love the color our house ended up being - a color match that Excel performed for us - and expressed as such. David was a nightmare to work with once we mentioned we had a problem. He had terribe customer service skills and repeatedly made us feel like it was our fault and that we were stupid. Painting our house was a big commitment and investment in our eyes, and he was not the least bit helpful in trying to get us to an end product we would be happy with. In fact, he succeeded in making us even more unhappy to the point that we gave up on even having Excel repaint to get us to a color we'd be happy with. A very disappointing experience.
A thorough scrubbing is a must before painting any exterior surface. It removes the dirt and broken-down paint residues that keep fresh coats from adhering and gets rid of mildew that grows on paint in all but the most arid climates. Most contractors clean with pressure washers, but in the hands of someone unfamiliar with the equipment, these can gouge wood, shatter glass, and drive water behind siding and trim. Using a hose, a pump sprayer, and a scrub brush is slower but safer, and just as effective.
Even an old lamp with a bare bulb held close to a wall will make minor cracks, bumps or nail pops jump out. Carmen Toto, owner of C. Toto & Sons in Madison, New Jersey, uses painter's putty or a lightweight spackle for minor cracks and dents; he uses plaster of Paris for dents deeper than 1/8 inch. Instead of the standard tape-and-spackle method for bridging over recurring stress cracks, Maceyunas uses a rubberized spray-on primer called Good-Bye Crack. Damaged wood requires a slightly different approach. "Don't use spackle on wood," says Toto, "because it just won't stick." For damaged trim, he uses painter's putty or a two-part wood filler, such as Minwax's High Performance Filler. Smooth any repairs, bumps, and nibs with a drywall pole sander. For smoother walls and better adhesion, some of our pros sand all previously painted walls regardless of the shape they're in.
"There's wisdom in a multitude of counsel" {Bible Book of Wisdom/Proverbs} I thank you all I learned so much here not only painting but contracting in general. After all this I realize how blessed my ignorance not taken advantage of by Greater Philadelphia area motivated young skilled pride-in-work honest hardworking + seasoned older employee of Scott Gribling Painting of Lansdale PA. I'm proud I had the idea that Tom Parkinson here taught me the phrase & affirmed paying daily "progress draws" & purchase receipts instead of advance deposit in case something happens to contractor, and as Tom teaches the natural effectiveness of receiving from the day's work :)
The other difficult part is getting a painting contractor to show up. While this generalization does not apply to every painter, personally I am extremely grateful if I can get a paint contractor to show up to look at the house and to later produce a written estimate. I hardly fault the painting contractors, because I think it is a combination of the contractors being smaller operations along with a high demand for their work.
to be the devils advocate i have been a building contractor 20 of the last 30 yrs. i do know that if you go to a higher sheen of paint and or darker colors then any imperfections in the walls will show up much more dramatically…therefore the painter or a good drywall finisher is needed to prepare the walls extensively. this could cause more expenses…for it takes a lot of time to prep walls (smooth walls..not textured walls) and this cost has to be absorbed.

Inspect the surface area for holes, cracks or other problems and apply acrylic caulk to fill them in. Use a putty knife to smooth out the caulk and remove any excess to prevent bumps. For particularly thin or narrow crevices, you may have to use your finger to smooth out the caulk. Caulk contracts and shrinks, so apply a second layer once it's dried.


Customer Service/Scheduling: I ended up being admitted to the hospital about a week or so after we decided to go with Excel, with pregnancy related complications. When they reached out to me as a reminder for the deposit, I explained my situation, and asked for a little more time to see if we could even proceed. Without hesitation, they said this was not an issue. This company cares about the people they are working with, not filling up every single day with a job. We also went back and forth. At first we cancelled, and then we asked for the dates back, and they were so accommodating.
"Cutting in is an acquired skill, but it's something you can't do at all with a ratty brush," says Doherty. When cutting in on a wall, he loads his brush and spreads out the excess paint, then works the brush up to the line between wall and ceiling. A brush stroke that's too wide creates a hatband, or smooth brushed band, on the very top of the wall where it meets the ceiling. To avoid this, Dixon recommends rolling first and then cutting in with a brush. "A good roller can get within 1/2 inch of the ceiling," he says. "You'll save time by not brushing more then you have to." When painting baseboards, "a wide taping knife makes a good paint guard," says Span. "Just keep the blade clean to prevent drips from working around the edge of the knife."
Dave, you said it best! Every pro painting contractor truly worth their salt would and should cut and paste exactly what you say here about where customary and legitimate practices and expectations should be in regards to what customers should expect from contractors and how contractors should professionally deal with their customers. By the way, Dave, if you work in the Atlanta area, I would like to hire you! Thank you for your valuable advice!
First off, the picture on the top THAT IS A HOME OWNERS PAINT JOB. If you here a school kid or your neighbor, this is what you get. I was a painting contractor for the better part of 40 years and never saw a PAINTER (even the worst painter) leave a mess like that. Maybe the electrician or the carpenter but, that is not something a painter could even do if they tried.
O'Neil patches shallow holes and divots with Ready Patch because it dries fast, sands smooth, and stays flexible. Deep cracks and rotten spots are best repaired with two-step epoxies, such as those made by Advanced Repair Technology. (For a step-by-step instructions, see Repairing Rot with Epoxy.) The days of using polyester auto-body fillers on wood are over. "They cure too hard," says Portland, Oregon–based painting contractor Kathleen George. "They look good at first, but then they peel away."
Paint gets more expensive as you go from flat to gloss. The difference is usually around $1 per gallon per sheen upgrade. Flat is the cheapest, then matte flat or eggshell, satin, semigloss then gloss. Paint also gets much more expensive the darker it gets. A white or neutral paint color can be as much as $20 less expensive than a deep base red or blue.
When you choose Five Star Painting residential house painting contractors, you can feel confident that you are hiring the best in the business. Local Five Star painters have been serving clients throughout the United States and Canada since 2004. From taking time to prepare the area to using exactly the right equipment for each job, we make sure the project is done correctly. Our experience shows: We’re good at what we do, and our clients are always happy with the work we leave behind!
The article and comments were great information to have before deciding how to go about getting a painting job done. I think the important point is that there are several key choices (who to do the work; color, sheen, quality, of paint; how many coats; amount of prep/repairs to be done and by whom, how long the job will take, provisions for changes, how detailed the contract needs to be; advanced deposit/progress payments/final payment; final inspection, etc.) that need to be made and it requires advanced research and planning in order to become well enough informed to make the right choices. Then it requires spending sufficient time to check materials and inspect the quality of the work while it is on-going, raher than waiting to do it all at the end. President Reagan's philosophy of "Trust, but verify." applies.
"Five Star Painting painted the exterior of our home and we were very satisfied. They spent a lot of time prepping the home prior to painting and they used high quality paint. From the initial appointment to the clean-up they were conscientious and courteous. We love that they offer a 2 year warranty. We would definitely recommend Five Star Painting!"
When you refinish your existing cabinet doors, you get a whole new look without the astronomical costs normally associated with a kitchen remodel. It’s a much smarter way to update your space, especially if your cabinets are still in good condition. It doesn’t make sense to throw out perfectly good materials, just because you’re tired of the color.
There are permanent features of the home that have their own colors which cannot be changed when painting the exterior of the home but can have a dramatic satisfaction level that is experienced when the painting is completed.  Roofing shingles, paving blocks, concrete surfaces, stones and other such features are prime examples of the colors that should be considered when selecting your exterior color scheme for the home.  Homeowners can work off of these colors to make a home that looks uniform and luxurious when the exterior painting is complete.
Even if you go it alone, specialize to keep your initial investment low. If you do only interior painting, for example, you might get by with one ladder, a few brushes, rollers, basic hand tools and such, for an investment of less than $300. Again, you can add to your tools as you need to (every job is a bit different), and parlay profits into the equipment necessary for exterior painting or working on large commercial properties.

When their bids are successful, contractors meet customers to finalize their requirements and plan the order and timing of work. Contractors estimate the time required for surface preparation, painting several coats and drying time between coats. For interior painting jobs, they might have to allow time for clearing rooms. Exterior painting schedules might be dependent on the weather in different parts of the country. Exterior painting is not practical in very wet or very cold conditions.

×