to be the devils advocate i have been a building contractor 20 of the last 30 yrs. i do know that if you go to a higher sheen of paint and or darker colors then any imperfections in the walls will show up much more dramatically…therefore the painter or a good drywall finisher is needed to prepare the walls extensively. this could cause more expenses…for it takes a lot of time to prep walls (smooth walls..not textured walls) and this cost has to be absorbed.
When determining the total cost of a home exterior paint project, you'll want to include the cost of materials like paint, supplies and other items you might want to cover in addition to the siding. If you know the average cost of these items in addition to your home exterior project cost, you'll have a good plan in place when you start calling for professional estimates. This also gives you the option to purchase or paint some items yourself to save money. Here are some of those cost factors and what you might expect to pay:
Familiarize yourself with construction codes and regulations. All cities have laws that dictate things like how contractors can do business, what types of materials and equipment are okay to use and how professional contracts should be handled. It will be necessary for you to have a working knowledge of these regulations as a private contractor. You can study them on your own time while you’re finishing an apprenticeship or receiving on-the-job training.[9]
Painting services are relatively low in price when considering the value they can add to a home. Rental properties that are in good condition with clean, fresh paint can fetch higher prices from tenants. Additionally, this applies to homes on the market. A little bit of paint can increase the value and grab the attention of prospective buyers. Lastly, repainting every few years can keep the decor fresh to ensure that homeowners do not tire of the colors they chose. Bright colors can make a Jacksonville home really feel like a beach getaway.
Buying a can of premium paint, then bait and switch over to low-line products? Again, complete nonsense. Think about it for a moment; the Painter needs 5 gallons of wall finish. So, he buys one can of premium and the rest 'cheap'? How is he going to hide the 4 other gallons? What's he going to hide it in??? He only has ONE gallon of premium. It's not as though he's going to keep older can labels, they would be covered in paint of a different colour.
My friend already posted about this, but the incident is so outrageous it deserves two postings. On a lovely Sunday afternoon, we were out on a  walk and waiting, patiently, on 65th and 1st for the east-west traffic to stop and allow us to cross. When the eastbound traffic was clear, a car heading west stopped to let us cross. Behind this law-abiding driver, heading west, was the Excel Home Painting van. The Excel driver immediately started honking at the car in front of him--you know, the one that stopped to allow pedestrians to cross--and then screaming and cursing at us, including calling us "f**king bitches and whores." Why? Because we were crossing the street. Really?
Most painters have no problem painting doors in place, but they recommend you lay the door on sawhorses and work horizontally. If you have a paneled door, start with the panels and work from the outside edges in toward the center. "Watch the corners — paint loves to puddle," warns Dixon. While the paint is still wet, lightly "tip off" the panel with an almost dry brush. (Tipping off is pulling the brush over the surface to level out the finish.) When painting the stiles (vertical) and rails (horizontal) just follow the grain of the wood. When the grain changes abruptly, for instance, where the rail meets the stile, don't stop your brush stroke — you'll only leave a lump of paint. Apply paint across the joint with a full stroke, and then tip off the overlapping section by pulling the brush in the direction of the grain. "Make sure the door is dry before painting the opposite side or rehanging it," says Maceyunas.
Thanks, all, for your time & efforts adding to the article & comments, especially Dave urging requesting both General Liability AND Worker Compensation insurance certificates to protect from real & fraudulent liability--from my experience especially in California, where insurance fraud is a popular income thief, even causing car collisions to collect.

The other difficult part is getting a painting contractor to show up. While this generalization does not apply to every painter, personally I am extremely grateful if I can get a paint contractor to show up to look at the house and to later produce a written estimate. I hardly fault the painting contractors, because I think it is a combination of the contractors being smaller operations along with a high demand for their work.
If your home was built before 1978, there is a good chance that lead paint was used in its construction. Scraping, sanding, or removing old paint can release toxic lead dust which can cause serious illness in children and pregnant women. Special handling is required when working with lead-based paints. If lead paint is present in your home, you will need to hire a lead-certified painting contractor or lead abatement contractor. Before getting started with your exterior painting project, consult your local building authority or visit www.epa.gov for more information. 

The inland suburbs to the west, such as Orange Park and Fleming Island, are known for their reasonable housing prices. The more rural setting means that the homes in this area are very similar to homes in suburbs across the country rather than the large beach houses seen in Jacksonville’s seaside towns. Homes here have reasonable square footage, which can bring the cost of painting services down.
If you're going to do any part of the painting or prep work on your own, you must know that the first step in preparing a surface is washing it. Since dirt can affect the smoothness of a surface area -- and therefore paint's adhesion to it -- use soap to remove any dirt or stains. Make sure there's no soap left on the walls when you're finished; also make sure to remove any gloss with sandpaper and vacuum up the leftover dust.
Most painters have no problem painting doors in place, but they recommend you lay the door on sawhorses and work horizontally. If you have a paneled door, start with the panels and work from the outside edges in toward the center. "Watch the corners — paint loves to puddle," warns Dixon. While the paint is still wet, lightly "tip off" the panel with an almost dry brush. (Tipping off is pulling the brush over the surface to level out the finish.) When painting the stiles (vertical) and rails (horizontal) just follow the grain of the wood. When the grain changes abruptly, for instance, where the rail meets the stile, don't stop your brush stroke — you'll only leave a lump of paint. Apply paint across the joint with a full stroke, and then tip off the overlapping section by pulling the brush in the direction of the grain. "Make sure the door is dry before painting the opposite side or rehanging it," says Maceyunas.
I learn a lot from this show and it help in my building maintenance job. i like this about the regulator on gas meter but for the cut away I know it had to be that way but Richard could you have mentioned that there was a vent on the regulator. I had a coworker ask me to check the vent and make sure it was clear, but from your cut away and no mention of a vent in the demo I didn't know there was a vent on the regulator so for next time there may need to be 2 cut aways explaining what the meter is and how to be safe.

Steve, not only did you come off with an edge regarding the article written for Angie's list but you came awfully close to being slanderous. The article was written if you will have read his bio by a very well established professional painter. The issue regarding the deposit was put in question by a responder. I have read your response in full as you suggested, and companies as large as yours are just as likely to use the tricks of the trade as the small guy as you suggest, if not more so. A large company has less oversight and workers get lazy with the boss not looking over their shoulder. I have had experience in this area, and thought that i was dealing with a very reputable company that had been recommended by a couple friends, my insurance company, and my adjuster who had dealt with the company. I had terrible problems with the company, who do full restorations and like your company paint in all areas. To finalize your statement that Established businesses do not cheat customers is completly false and is a very misleading statement. I am suprised that Angies list allowed you to post such an outragious comment. All you have to do is look in the Civil lawsuits section of the Established businesses that are being sued or are under investigation for fraud and cheating their customers!
The materials of the home’s facade should be considered before painting your home. When painting flat surfaces like siding or wood, you can opt for standard outdoor paint. When painting a textured surface like stucco or brick, “elastomeric” paint is a much better choice. This type of paint can stretch more than normal paint, which allows it to bridge over small gaps and crevices, painting smoothly over texture.

Recently I had the outside of my home painted. The contractor wrote a good contract, but I failed to realize that some things were not in it. It reminds me of the car dealer who offered a good price on a new car but failed to mention that it did not include tires. My contractor failed to specify that lattice under a porch was included. So the painters did not paint it. To his credit, he did instruct them to paint it when I brought it to his attention. If I had the job to do over again I would look for an individual who came with referrals from happy customers rather than a franchise owner..


When you choose Five Star Painting residential house painting contractors, you can feel confident that you are hiring the best in the business. Local Five Star painters have been serving clients throughout the United States and Canada since 2004. From taking time to prepare the area to using exactly the right equipment for each job, we make sure the project is done correctly. Our experience shows: We’re good at what we do, and our clients are always happy with the work we leave behind!

The cost to paint metal siding -- most commonly aluminum and galvanized steel -- will depend on a variety of factors. In some instances, a simple cleaning will suffice to prepare metal siding for painting. In worst cases, painting professionals will need to repair metal that is rusted, damaged or missing pieces due to climate conditions. In the case of severe damage, a professional will have to remove the old finish and paint to get to the original layer, which will add on to the final price. When you add the actual painting of the metal siding, you might be looking at a final bill between $400 (~250 sq. ft.) and $1,500 (~1,000 sq. ft.).


Your small home is the perfect spot for a sunny little kitchen. A warm yellow like Benjamin Moore's Hawthorne Yellow would look great with white cabinets, subway-tile walls, and a weathered gray tile floor. The secret to choosing the right yellow paint color for your small kitchen is to sample light yellow colors first, then increase the intensity if you don't get the look you want right away.
The color scheme that is chosen for the home creates the initial impression that an individual has of the premises as a whole.  Whether complimentary or unflattering colors are selected, the house will gain an identity of its own when the paint is applied.  There are many times that a homeowner misses opportunities to accentuate positive attributes that the home has to offer by failing to choose the best exterior paint colors. 
×